Unix Binary Installation - Manual do Geomview
Description: Manual do Geomview

Next: Source Code Installation, Previous: Instalacao, Up: Instalacao

### 10.1 Instalando os Binários Unix

> BUG: This section is out of date. `Geomview` follows the GNU-installation habits, data goes to `PREFIX/share/geomview/`, user executables to `PREFIX/bin/`, private executables to `PREFIX/libexec/geomview/`, libraries to `PREFIX/lib/` where `PREFIX` denotes the installation prefiex specified for the `TOPSRCDIR/configure` script. Please have a look at the files `TOPSRCDIR/INSTALL` and `TOPSRCDIR/INSTALL.Geomview` for installation instructions.

If you have just obtained a copy da binary distribution for a Unix system (Linux, SGI, Solaris, HP, etc), you should be able to run Geomview and make use of most of its features immediately after unpacking it by `cd`'ing to the directory that it is in and typing `geomview`.

In order to fully install Geomview so that you can run it from any directory and use all of its features, follow the steps in this section. In particular, you must go through this installation procedure in order to use Geomview to display Mathematica graphics.

Geomview is distributed in a directory that contains various files and subdirectories that Geomview needs at run-time, such as data files and external modules. It also contains other things distributed with Geomview, such as documentation and (in the soure-code distribution) source-code. We refer to the root directory of this tree as the `$GEOMROOT` directory. This is the directory called `Geomview` that is created when you unpack the distribution file.

To install Geomview on your system, arrange for the `$GEOMROOT` directory to be in a permanent place. Then, in a shell janela, `cd` to that directory and type `install`. This runs a shell script which does the installation after asking you several questions about where you want to install the various componentes of Geomview.

After running the `install` script you should now be able to run Geomview from any directory on your system. (You may need to give the `rehash` command in any shells on your computer that were started up before you did the installation.)

The `install` script puts copies dos files in `$GEOMROOT/bin/<CPU>` and `$GEOMROOT/man` into the directories you specified for executables and man pages, respectively. Once you have done the installation you can cut down one the disk space required by Geomview by removing some files from these directories, since copies have been installed elsewhere. You should first test that your installed Geomview works properly because once you remove these files from their distribution directories you will not be able to do the installation again.

In particular, the files you can remove are

`$GEOMROOT/bin/<MACHTYPE>`:
  (where `<MACHTYPE>` is the type of system you are on, e.g. `linux`, `sgi`, `hpux`, etc). Remove all files from here except `gvx`, which is the geomview executable file. DO NOT REMOVE `gvx`. It is not installed elsewhere.
`$GEOMROOT/man`:
  You can remove all the files in this directory.